Process Control Solutions — Haldia, West Bengal
We provide end-to-end design, development, engineering, and commissioning of industrial process control systems based on proven PLC, RTU, and HMI/SCADA platforms — designed and commissioned on-site from Haldia, West Bengal.
Supported Hardware Platforms
PLC-Based Systems
- GE FANUC CPU 90-30
- Emerson RX3i Control System
- Schneider Electric Quantum & Modicon M580
RTU Systems
- GE FANUC CPU-001
- Schneider Modicon M340 & Easy M200
- Siemens SIMATIC Series
HMI / SCADA Software Overlays
Our Services
- PLC/RTU configuration & programming
- HMI / SCADA screen development
- Factory Acceptance Test (FAT)
- Site Acceptance Test (SAT) & commissioning
- Maintenance & technical support
Built for Haldia's Process Manufacturing Base
Haldia and the surrounding West Bengal industrial belt are home to refineries, petrochemical plants, and heavy process manufacturers — the kind of sites where a control system has to run continuously, integrate with equipment from multiple vendors bought over different decades, and give operators a single HMI view instead of five disconnected panels.
That's the gap this work fills: taking PLC and RTU hardware from GE FANUC, Emerson, Schneider Electric, or Siemens — often already installed, sometimes new — and building the ladder logic, Modbus communication, and SCADA/HMI overlay (GE CIMPLICITY, AVEVA Citect) that turns individual controllers into one operable process.
We design, program, and commission these systems on-site across Haldia and the surrounding industrial belt, including Durgapur, Howrah, and Kharagpur, for plants that need process control engineered around their actual equipment mix rather than a one-size-fits-all package.
Commissioning & Support
Assessment.We start by mapping your existing PLC/RTU hardware, I/O points, and control logic — what's already there, what needs replacing, and what the new system needs to do that the old one couldn't.
Programming and HMI build. Ladder logic, Modbus communication, and the SCADA/HMI screens are built and bench-tested against your process requirements before anything touches the live plant.
Factory Acceptance Test (FAT). The system is tested as a whole in a controlled environment, verifying I/O response, alarm logic, and HMI behavior before it ships to site.
Site Acceptance Test (SAT) and commissioning.On-site testing against real process conditions, followed by commissioning and operator handover — with maintenance and technical support available afterward since we're based in Haldia.
Frequently Asked Questions
Can you work with the PLC/SCADA hardware we already have installed?
In most cases, yes. We work with GE FANUC, Emerson RX3i, Schneider Electric (Quantum, Modicon, Easy series), and Siemens SIMATIC platforms, and we assess your existing hardware during the initial site visit rather than assuming a rip-and-replace.
What's the difference between FAT and SAT?
Factory Acceptance Testing (FAT) verifies the system works correctly in a controlled bench environment before it ships. Site Acceptance Testing (SAT) verifies it against your actual process conditions on-site, before final commissioning.
Do you provide ongoing maintenance after commissioning?
Yes — being based in Haldia means follow-up support, troubleshooting, and maintenance visits don't require mobilizing an engineer from another city.
Can the SCADA/HMI system integrate multiple PLC brands into one view?
Yes, that's a common requirement on plants that have added equipment from different vendors over time — the SCADA/HMI layer (GE CIMPLICITY or AVEVA Citect) is built to unify status and control across mixed hardware via Modbus.
Do you serve plants outside Haldia?
Yes — we design, commission, and support process control systems across the West Bengal industrial belt, including Kolkata, Durgapur, Howrah, and Kharagpur.